Truck and trailer lights are better protected and more attractive with a mounting box. This one is aluminum and diamond-plated.
The pair of 22-inch Polyethylene cases hold 4 lights in each. A red LED Tail/ Stop light, an amber LED turn signal, a clear LED backup light and a 2" LED side marker light.
For your 2" or 2-1/2" lights we have these black powder coated steel brackets so that you don't have to drill large holes in your truck or trailer for lights.
This steel welded box fits the standard oval 6 or 6-1/2" oval tail light with rubber grommet. The side of the is box is already pre cut for a 2" marker light and rubber grommet. Just drill your own holes for mounting or just weld it on!
This hitch available with 3 different sizes of forged steel ball. 8 Ton capacity, black powder coat finish. Drawbar eye dims: 1-1/2" to 3" ID with 1-1/4" to 1-9/16" diameter section. M.V.L 3000 lbs. M.G.T.W. 16,000 lbs.
RAM mounting arm is 6" long with a 2.5" base that holds a 1" ball for swiveling the arm. At top of arm there is another 1" ball mounted to a 1 x 1 plate which will hold a single stud mounted light. Great permanent mount for UTVs, tractors, & any off road vehicle. This mounting arm supports up to 5 lbs. (light in picture not included)
This black powder coated steel chock with fit various tire widths, 18" long x 12" wide x 12-1/4" tall. Can be mounted to truck beds, garage floor, trailers etc...
These 4" x 4" x 8" ribbed rubber chocks are used for aircraft, ground equip. or large pipe.
These chocks have a 36" nylon cord and are great for ATVs and similar vehicles. NOT for auto or truck use.
These yellow composite wheel chocks are made of recycled plastic.